Leen-Powered Integrations

Introduction

Sysdig partners with Leen, a third-party integration provider, to facilitate secure and seamless connections with external security tools. The integrations listed on this page are powered by the Leen framework, which manages the authorization and data flow between Sysdig and the third-party vendor.

All integrations using this framework share a common, one-time activation process and can be managed centrally.

Supported Integrations

The following integrations are currently available through the Leen framework.

Snyk

• Type: Software Composition Analysis (SCA)
• Purpose: Enriches Sysdig’s runtime vulnerability findings with source code context from Snyk, such as recommended fix versions and dependency file paths.
• Setup Guide: See Software Composition Analysis for detailed configuration instructions.

Semgrep

• Type: Software Composition Analysis (SCA)
• Purpose: Enriches Sysdig’s runtime vulnerability findings with source code context from Semgrep, providing faster root cause analysis and better remediation guidance.
• Setup Guide: See Software Composition Analysis for detailed configuration instructions.

Activation and Consent

The first time you configure any of the integrations listed above, you will be presented with a one-time Terms and Conditions modal. This modal explains the partnership and the data-sharing agreement required to proceed.

To enable the integration, you must review and consent to the following:

• Allowing Leen to establish a connection and share relevant data from the selected third-party security vendor with your Sysdig account.
• Understanding that Leen will act as a subprocessor for the data being transferred from the vendor to Sysdig.
• Agreeing to Leen’s Terms and Conditions for using the service.

After clicking Enable Leen and accepting the terms, the modal will not be shown again for any subsequent Leen-powered integrations you configure.

Managing Leen Integrations

If you need to opt out and disable all Leen-powered integrations at once, you can do so from the Sysdig settings.

1. Navigate to your user profile icon in the bottom-left and select Settings.
2. In the left-hand navigation pane, go to Sysdig Sage > Third Party Integrations > Leen Activation and T&C.
3. Click the Disable Leen Integrations button.

This action will revoke your consent and immediately deactivate all active integrations managed through the Leen framework, stopping any further data sharing. You can re-enable the framework from this same page if you decide to use these integrations again in the future. Data is automatically deleted 48 hours after deactivation.